Vitotronic 100 — Scans For Every Boiler - Viessmann VITOTRONIC 100 Operating Instructions Manual

Scanning information
Vitotronic 100 — scans for every boiler
Subject to the connected components
and settings made, you can scan current
temperatures and operating conditions.
Press the following keys:
1. for settings; "
2. until " " flashes.
3. OK to confirm.
4. / for the required information.
5. OK to confirm; if you want to reset
the value to "0" (see following
table), " " flashes.
The information appears in the following sequence:
Display
0 1
2 107 °C Flue gas temperature
3 65 °C Boiler water temperature —
6 55 °C Temperature sen-
7 55 °C Temperature sen-
2 6 3 5 7 2
1
2 6 3 5 7 2
2
0 1 3.5 7 8
3
0 0 1 2 2 5
4
" flashes.
Explanation
LON subscriber number
sor aJA
sor aJB
h Hours run, burner single
stage, stage 1 or modu-
lating
h Hours run, burner
stage 2
Burner starts
Fuel consumption
6. OK to confirm; the value is reset.
Example:
On the display, you can see the number
"3" and the current boiler water temper-
ature.
¸
3
Note
The scan mode terminates automatically
after 30 min or if you press
Notes
Control unit has subscriber num-
ber 1.
Displayed only if a flue gas tem-
perature sensor is connected.
Only if a sensor is connected.
Only if a sensor is connected.
With "D" you can reset the value to
"0".
With "D" you can reset the value to
"0".
With "D" you can reset the number
of burner starts to "0".
With "D" you can reset the value to
"0".
Scanning options
°C
6 5
.
37