Chicco Oasys 1 isofix Instructions For Use Manual page 20

B. Shoulder straps
C. Child seat restraint harness
F. Harness open / close buckle
G. Seat Fabric
H. Padded crotch strap
I. Child seat base
J. Seat
K. Handle to release the ISOFIX system
Diag. 2 (Back)
N. Homologation labels
O. Isofix connectors
P. Top Tether
Q. Instruction manual holder
Diag. 3 (Profile)
R. Installation instructions labels
S. ISOFIX system
Diag. 4 (ISOFIX System Detail)
T. Connectors
U. Protective caps
V. Release buttons
W. Locking indicators
Diag. 5 (TOP TETHER Detail)
AA. Belt
CC. Tension indication
DD. Hook
RESTRICTIONS AND REQUISITES RE-
GARDING THE USE OF THE PRODUCT
AND CAR SEAT
WARNING! Read these use restrictions and
requisites carefully to ensure the product is
used safely.
9 up to 18 Kg of weight.
ISOFIX system in the positions indicated in
the instructions for use of the vehicle.
WARNING! If the vehicle manual allows
ISOFIX installation of the child car seat on
the front seat of the car, in order to ensure
maximum safety, it is recommended to push
the seat back as much as possible, bearing in
mind the comfort of the passenger sitting in
backrest to the most vertical position. It is not
recommended to fit the child car seat into a
front seat equipped with airbag. If you wish to
fit the child car seat in any seat protected by
airbag, always refer to the vehicle instructions
manual.
FITTING THE CHILD CAR SEAT INTO THE
CAR WITH THE ISOFIX SYSTEM
Preparing for installation
1. Pull the unlocking handle (K) of the ISOFIX
system externally (diag. 6).
2. While keeping the handle pulled, pull out
the ISOFIX system COMPLETELY from the
rear of the backrest (diag. 7). Ensure that the
system has been pulled out as far as possible.
3. Push the two red buttons (Y) of the ISOFIX
connectors inwards (diag. 8) and remove the
two protective caps. 9).
4. Place the two caps into the appropriate
compartments, located between the base
and the seat, once the latter has been reclined
completely (diag. 10).
WARNING! Store the caps carefully, since
they are indispensable for reinserting the
ISOFIX system in to the base when the system
is not in use.
How to fit the child car seat
5. Place the child car seat onto the vehicle
seat following the recommendations provided
in the instruction manual of your vehicle.
WARNING! Check that there are no loose
seat or between the child car seat and the door
of the car.
6. Insert the two ISOFIX connectors into the
corresponding ISOFIX locking devices, located
on the cars seat, between the backrest and
the seat (diag. 11). WARNING! Pull the child
car seat towards you to ensure it has been
installed correctly and then check that the two
indicators (W) are green.
7. Push the child car seat firmly against the
20