Specific Safety Rules - CHICAGO 92956 Operating Instructions Manual

21. Maintain tools with care. Keep cutting tools sharp and clean. Properly
maintained tools with a sharp cutting edge are less likely to bind and are easier
to control. Do not use a damaged tool. Tag damaged tools "Do not use" until
repaired.
22. Check for misalignment or binding of moving parts, breakage of parts,
and any other condition that may affect the tool's operation. If damaged,
have the tool serviced before using. Many accidents are caused by poorly
maintained tools.
23. Use only accessories that are recommended by the manufacturer for your
model. Accessories that may be suitable for one tool may become hazardous
when used on another tool.
24. Tool service must be performed only by qualified repair personnel. Service
or maintenance performed by unqualified personnel could result in a risk of injury.
25. When servicing a tool, use only identical replacement parts. Follow
instructions in the "Inspection, Maintenance, And Cleaning" section of this
manual. Use of unauthorized parts or failure to follow maintenance instructions
may create a risk of electric shock or injury.
1.
Hold tool by insulated gripping surfaces when performing an operation
where the cutting tools may contact hidden wiring or its own cord. Contact
with a 'live' wire will make exposed metal parts of the tool 'live' and shock the
operator.
2. Always wear ANSI approved safety impact eye goggles and full face shield
when operating this product.
3. Maintain labels and nameplates on the Drill. These carry important
information. If unreadable or missing, contact Harbor Freight Tools for a
replacement.
4. Do not reach under or behind the material being drilled.
5. Make sure the workpiece is free from nails and any other foreign objects
which can damage a drill bit.
6. Maintain a firm grip with both hands on the Drill, and position your body
and arm to allow you to resist torque forces.
7. Do not use a dull or damaged drill bits. Unsharpened or damaged drill bits
cause excessive friction and binding.
8. Use caution when drilling into existing walls or other blind areas. Check for
unexposed electrical wires and cables in the drilling path before drilling.
SKU 92956 For technical questions please call 1-800-444-3353
SERVICE

SPECIFIC SAFETY RULES

PAGE 5