SAVE THESE INSTRUCTIONS WORK AREA Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents. SKU 92956 For technical questions please call 1-800-444-3353 PAGE 2...
When operating a power tool outside, use an outdoor extension cord marked “W-A” or “W”. These extension cords are rated for outdoor use, and reduce the risk of electric shock. SKU 92956 For technical questions please call 1-800-444-3353 PAGE 3...
Store idle tools out of reach of children and other untrained persons. Tools are dangerous in the hands of untrained users. SKU 92956 For technical questions please call 1-800-444-3353 PAGE 4...
Do not use a dull or damaged drill bits. Unsharpened or damaged drill bits cause excessive friction and binding. Use caution when drilling into existing walls or other blind areas. Check for unexposed electrical wires and cables in the drilling path before drilling. SKU 92956 For technical questions please call 1-800-444-3353 PAGE 5...
Page 6
If damaged, have it repaired by a service facility before use. If the plug will not fit the outlet, have a proper outlet installed by a qualified electrician. SKU 92956 For technical questions please call 1-800-444-3353 PAGE 6...
Standard Association, and the National Electrical Code. (See Figure B.) Double insulated tools may be used in either of the 120 volt outlets shown in the following illustration. (See Figure B.) SKU 92956 For technical questions please call 1-800-444-3353 PAGE 7...
Always replace a damaged extension cord or have it repaired by a qualified electrician before using it. Protect your extension cords from sharp objects, excessive heat, and damp or wet areas. SKU 92956 For technical questions please call 1-800-444-3353 PAGE 8...
Page 9
150% of the rated amperes. FIGURE C SYMBOLOGY Double Insulated Underwriters Laboratories, Inc. Canadian Standards Association Volts Alternating Current Amperes No Load Revolutions xxxx/min. Per Minute (RPM) FIGURE D SKU 92956 For technical questions please call 1-800-444-3353 PAGE 9...
Hammer Drill has come to a complete stop. (See Figure D.) DRILL CHUCK (3) FORWARD/REVERSE SWITCH (35) TRIGGER (30) TRIGGER LOCK (34) TO LOOSEN FIGURE D CHUCK KEY POWER CORD/PLUG TO TIGHTEN (33) (31) SKU 92956 For technical questions please call 1-800-444-3353 PAGE 10...
Page 11
To reduce jamming as the drill bit breaks through the workpiece, decrease the drilling pressure when the point of the drill bit breaks through the workpiece. SKU 92956 For technical questions please call 1-800-444-3353 PAGE 11...
After cleaning or replacement, replace the Brush Holders. NOTE: New Carbon Brushes tend to arc or spark when first used until they wear and conform to the Motor’s Armature. (See Figure E, next page.) SKU 92956 For technical questions please call 1-800-444-3353 PAGE 12...