Product Features - CHICAGO 92956 Operating Instructions Manual

When unpacking, check to make sure all accessories listed above are included, and that
the product is intact and undamaged
For additional information regarding the parts mentioned in
the following pages, refer to the Assembly Diagram on page 14.
1. Drill Chuck (3) and Chuck Key (33): The Close Quarter Drill is equipped with a
3/8" keyed Drill Chuck (3) that will accept drill bits (not included) with a 1/16" to
3/8" shank. Installing a drill bit into the Drill Chuck requires the use of the
accessory Chuck Key (33). Always make sure the drill bits are firmly secured in
the Drill Chuck prior to using the Drill. (See Figure D.)
2. Trigger (30) and Trigger Lock (34): The Trigger (30) is operated manually
simply by squeezing the Trigger to turn on the Drill and releasing pressure on the
Trigger to turn off the Drill. The Trigger features a Trigger Lock (34) for continuous
running of the Drill. To set the Drill in a continuous run mode, squeeze the
Trigger and depress the Trigger Lock. Then, release pressure on the Trigger.
The Drill will continue to run. To turn off the Drill, squeeze and let up on the
Trigger. (See Figure D.)
3. Forward/Reverse Switch (35): The Forward/Reverse Switch (35) is located
directly above the Trigger (30). For clockwise rotation, move the Forward/
Reverse Switch to the right . For a counterclockwise rotation, move the
Forward/Reverse Switch to the left . Use the Forward/Reverse Switch only after
the Hammer Drill has come to a complete stop. (See Figure D.)
DRILL CHUCK (3)
FORWARD/REVERSE SWITCH (35)
TRIGGER (30)
CHUCK KEY
(33)
SKU 92956 For technical questions please call 1-800-444-3353
UNPACKING

PRODUCT FEATURES

NOTE:
TO LOOSEN
TO TIGHTEN
TRIGGER LOCK (34)
POWER CORD/PLUG
(31)
FIGURE D
PAGE 10