Start-Up And Use; Starting The Dishwasher; Loading The Detergent - Indesit Idl 507 Instruction Booklet

Start-up and use

Starting the dishwasher

1. Turn the water tap on.
2. Press the ON/OFF button: the indicator light will
illuminate.
3. Open the door and pour in a suitable amount of
detergent ( see below ).
4. Load the racks ( see Loading the racks ) and shut
the door.
5. Select the desired wash cycle depending on the
dishes and how dirty they are ( see table of wash
cycles ), by turning the knob clockwise.
6. Select the wash options* ( see below ).
7. Start the cycle by pressing the START/RESET
button: the machine will emit a confirmation beep.
The WASH CYCLE PHASE indicator lights display
the status of the cycle:
Pre-wash, Wash,
8. At the end of the cycle three short beeps will sound
and the DRYING indicator light will flash.
9. Switch off the appliance by pressing the ON/OFF
button, shut off the water tap and unplug the
appliance from the electricity socket.
10.Open the door and wait for a few minutes before
removing the crockery, in order to avoid burns.
Unload the racks, beginning with the lower level.
Modifying the wash cycle in progress
If a mistake was made during the wash cycle selection
process it is possible to change the cycle, provided
that it has only just begun: press and hold the START/
RESET button for 4 seconds. After one long beep and
three short beeps, the WASH CYCLE PHASE indicator
light will switch off: select the new cycle and switch
the machine back on by pressing the START/RESET
button.
Adding extra crockery
Press the ON/OFF button and open the door, taking
care to avoid the escaping steam, and place the
crockery inside the dishwasher. Press the ON/OFF
button again: the cycle starts from the point at which it
was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if there
is a power cut, the cycle stops. It starts again from the
point at which it was interrupted once the door has
been shut or the electricity supply is restored.
Rinse, or Drying.

Loading the detergent

A successful wash also depends on the correct
amount of detergent being used, as recommended by
the manufacturer. Exceeding the recommended
amount does not result in a more effective wash and
pollutes the environment.
 To obtain the best results from each washing and
drying cycle, powder detergent, rinse aid liquid and
salt should be used.
compartment A: Washing detergent
compartment B: Pre-wash detergent
D
A
B
C
requires 1 tablet, place it in compartment A and
close the cover; when it requires 2, place the
second tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
* Only available in selected models.
1. Open cover C by
pressing button D.
2. Pour in the detergent
after consulting the Wash
cycle table :
• for powder detergent
use compartments A and
B
• for tablets, use
compartment A and the
bottom of the appliance,
i.e. when the cycle
17
EN