Maximizing The Battery Life; Managing The Battery Power; Power-Saving Modes - Lenovo ThinkPad X1 Carbon User Manual

Note: To maximize the life of the battery, the computer does not start recharging the battery if the remaining
power is greater than 95%.

Maximizing the battery life

To maximize the life of the battery, do the following:
• Use the battery until the charge is completely depleted.
• Recharge the battery completely before using it. You can see whether the battery is fully charged from the
battery-status icon in the Windows notification area.
• Always use power-saving modes, such as sleep mode, and hibernation mode.

Managing the battery power

To achieve the best balance between performance and power saving, adjust your power plan settings.
To adjust power plan settings, do the following:
1. Go to Control Panel, then change the view of Control Panel from Category to Large icons or Small icons.
2. Click Power Options.
3. Follow the instructions on the screen.
For more information, refer to the help information system of the program.

Power-saving modes

There are several modes that you can use at any time to conserve power. This section introduces each
mode and gives tips on the effective use of battery power.
• Screen blank mode (for Windows 7 only)
The computer display requires considerable battery power. To turn off the power to the display and make
the computer enter screen blank mode, right-click the battery gauge icon in the Windows notification area
and select Power off display.
• Sleep mode
In sleep mode, your work is saved to memory, and then the solid-state drive, hard disk drive, or hybrid
drive, and the computer display are turned off. When your computer wakes up, your work is restored
within seconds.
To put your computer into sleep mode, press Fn+4.
You also can put the computer into sleep mode by doing the following:
– For Windows 7: Open the Start menu, then click the arrow next to the Shut down button. Click
Sleep from the menu displayed.
– For Windows 10: Open the Start menu, click
• Hibernation mode
By using this mode, you can turn off your computer completely without saving files or exiting any
programs that are running. When the computer enters hibernation mode, all open programs, folders, and
files are saved to the solid-state drive, and then the computer turns off.
To put the computer into hibernation mode, change your power plan settings by doing the following:
– For Windows 7: Open the Start menu, then click the arrow next to the Shut down button. Click
Hibernate from the menu displayed.
– For Windows 10: Define what the power button does first, then press the power button to put the
computer into hibernation mode. For more information, see "Front view" on page 1.
Power, and then click Sleep.
Chapter 2
39
.
Using your computer