Bios Recovery - Recovering System Bios - Fujitsu Siemens Computers D2156 Technical Manual

Add-on modules / Upgrading

BIOS Recovery - Recovering System BIOS

i
All BIOS settings are reset to the default values.
► Open the casing as described in the operating manual.
► On the mainboard set the jumper to the appropriate setting to restore the system BIOS (see
chapter "Settings with switches and jumpers").
► Close the casing as described in the operating manual.
► Insert a BIOS update floppy disk and start the PC.
► Note the signals issued from the loudspeaker. You have successfully restored the BIOS if you
hear the signal sequence "short-short- long- long- long" and the diskette access indicator is
dark. This can take a few minutes.
► Open the casing as described in the operating manual.
► Restore the switch or jumper settings.
► Close the casing as described in the operating manual.
► Remove the floppy disk from the drive.
► Start the PC and invoke BIOS Setup.
► Select the menu item Reset Configuration in the menu Advanced and change the setting to Yes.
► Save the change and terminate BIOS Setup.
The BIOS recovery has now been completed. The system restarts.
Detailed information on the BIOS Setup and the BIOS recovery is contained in the "BIOS
i
Setup" manual (on the "Drivers & Utilities Collection", "Drivers & Utilities", "ServerStart" or
"User Documentation" CDs).
A26361-D2000-Z120-1-7419, edition 3 English - 27