Table of Contents
Advertisement
High Definition Audio - 2, 4 or 6-channel audio mode
Audio port front
High Definition Audio (yellow)
Pin
Signal
1
Micro input Left
3
Micro input Right
5
Right line / Headphone
output
7
Jack sense Send
9
Left line / Headphone output
When equipped with a high-definition audio controller the mainboard can support an 8-channel audio
output via the analogue audio channels (2 front, 2 side, 2 rear, 1 centre and 1 subwoofer channel).
This makes it possible to connect up to 8 loudspeakers, and therefore to achieve a better surround-
sound effect.
Drivers
A corresponding driver including the configuration tool must be installed for the 2, 4, 6 or 8-channel
audio mode. If the drive is not installed yet, proceed as described in the chapter "Add-on modules /
Upgrading", in the section "Drivers".
Connecting loudspeakers
The configuration tool detects the connection of loudspeakers for other audio devices. The Audio
Wizard of the configuration tool assures itself by asking about each connected audio device. Follow
the instructions on the screen.
The number of connected loudspeakers must match the selected number of audio channels which
you have set in the configuration tool (Speaker Configuration).
Special feature of sound recording
To record sound of a connected audio device, proceed as follows:
►
Connect the audio device if necessary.
►
Answer the query of the Audio Wizard.
►
Select the corresponding audio input for sound recording (see following table) as the standard
recording device (Control Panel - Sounds and Audio Devices - Audio tab).
►
Select the corresponding Audio Input Mixer in the Windows volume control (Options - Audio
Properties).
►
Set the desired recording level in the Windows volume control (for recordings).
10 - English
Basisinformationen Mainboard
1
Pin
Signal
2
Analogue GND
4
Presence Detect
6
Sense 1 return
8
Key
10
Sense 2 return
A26361-D2000-Z120-1-7419, edition 3
2
Hide quick links:
Advertisement
Table of Contents
