ACR Electronics Neo 1 Technical Manual page 5

Installing the Neo 1W/3W
To install the Neo wall hung version firstly check the suitability of the
wall where the appliance is to be mounted, paying particular attention to
the Neo 1W/3W section on location of unit earlier in this manual.
• Fully unpack the appliance and
remove the top casting plate
• Remove both cotter pins from the
retaining bar
• Remove the retaining bar by sliding it
in any direction and angling the bar
upwards before sliding the bar fully
out of the brackets
N.B. be careful to support the weight
of the mounting bracket when
removing the retaining bar
• Carefully tilt the mounting bracket
away from the appliance at the top
and remove from the bottom
supporting hooks
• Fully remove the mounting bracket
from the appliance the bracket is now
ready to be positioned against the wall
• Position mounting bracket against the
wall, making sure that the bracket is
perfectly level as this will affect the
leveling of the appliance
• The minimum distance above the
finished hearth level is 300mm
• Secure to the wall using a suitable
heavy duty wall fixing which is
applicable to the wall type and is also
heat resistant
• Use a minimum of 6 fixing points to
evenly spread the load
• Once mounting bracket is securely
fixed to wall position the bottom of the
appliance on to the hooks at the
bottom of the mounting bracket
• Tilt the appliance into the vertical
position and replace the retaining bar
and cotter pins as per previous
instruction