Related Manuals for ACR Electronics Astwood AW1MF
Summary of Contents for ACR Electronics Astwood AW1MF
- Page 1 TECHNICAL MANUAL The Astwood Multifuel Stove Model AW1MF To be retained by the user for future reference Serial Number ……………………………. Document AW1MF 0101 Thank you for purchasing an ACR Heat Products stove.
- Page 2 To ensure that you gain the most from your purchase, please take a few minutes to read through this manual before lighting the appliance for the first time. SINCE APRIL 2002 ONLY REGISTERED COMPETENT INSTALLERS CAN INSTALL SOLID FUEL APPLIANCES. INSTALLATIONS CARRIED OUT BY NON-REGISTERED INSTALLERS MUST BE INSPECTED BY LOCAL AUTHORITY BUILDING CONTROL.
- Page 3 ASTWOOD SPECIFICATIONS Nominal heat output ………… 7 kW – WOOD 6.8 kW – SMOKELESS FUEL Chimney draft required ……… 12Pa Height …………………………… 595 mm Width ……………………………. 545 mm Depth …………………………..415 mm Weight …………………………… 80 kg Direct Air Intake………………… 80mm Air Requirement ………………..
- Page 4 We do not recommend that plasma televisions and expensive artwork are hung over the fireplace. Please remember that this appliance has been designed to provide heat and if installed into a recess enough space should be left around the appliance to enable the heat produced to rise and escape from the recess back into the room.
- Page 5 Assembly of the unit The appliance is supplied assembled with the flue spigot in the top exit position. If you intend to install the appliance using a rear flue connection, the blanking plate should be swapped over as follows: Remove the internal baffle plate ...
- Page 6 User Instructions Please note that during the first firing, we recommend a small fire is lit and that you slowly increase the temperature to enable the various parts to expand normally. You may also experience fumes and a haze being given off by the stove during the first firing and possibly for the next couple of firings as the paint cures.
- Page 7 Instructions for use with wood Slide the top air control to the right and pull open the primary air fully. Lay firelighters or rolled up newspapers on the grate and add a small amount of kindling wood to the top. Place 1 or 2 small logs on the top. ...
- Page 8 Persistent fume emission is dangerous and must be investigated. If fume emission persists open doors and windows to ventilate the room and let the fire die out. Have the chimney inspected for blockages and clean if required. Do not relight the fire until the cause has been found. We recommend that you seek professional advice.
- Page 9 Troubleshooting Problem Probable Cause Action Recommended Fire difficult to Green wood / wet wood Use hardwood logs Start / Fire goes with a maximum moisture content of 20% Logs are too large Use small logs to start The fire and once Established use split logs Not enough primary air Open air control...
- Page 10 Commissioning Check List (Please mark box when completed) Ensure the serial number has been recorded on the front of this manual for any future use Ensure the door seals are in good condition and that the glass is secured correctly in the door (do not over tighten the glass as this will prohibit its expansion and could cause the glass to crack) Ensure that all internal components are fitted correctly (these may have shifted in transit)
- Page 11 Warranty Certificate The specifications within this document are provided for information purposes only and are under no circumstances binding. With the aim of constantly improving our products, all modifications considered necessary may be made without notice. Our appliances are guaranteed against faults and hidden defects subject to the following conditions: ...
- Page 12 Warranty Claim Form Customer Name: ……………………………………………………………………… Customer Address: ……………………………………………………………………. ……………………………………………………………………………………………… ……………………………………………………………. Postcode …………………. Daytime Tel: ……………………………. Mobile Tel: ……………………………… Model Name: …………………………… Model Number: ………………………. Serial Number: …………………………………………………………………………. Date of purchase: …………………………………………………………………….. Date of installation: …………………………………………………………………… Installer’s Name and address: ……………………………………………………… ………………………………………………………………………………………………...
- Page 13 Email: enquiries@acrheatproducts.co.uk...