Minolta Bizhub 36 Installation Manual page 7

10. Attach the mylar sheets. (Two places)
Note:
Make sure that the collar is completely covered
with the mylar sheet.
Collar
11. Cut open one corner of the supplied developer
(aluminum packet), and pour evenly into the
developer chamber, while turning the gear in the
direction of the arrow.
Note:
• Turn the magnet roller in the direction of its nor-
mal rotation, and not the backward.
• Not touching the gear of A side.
• Be sure not to let developer get inside the col-
lar.
Developer
Magnet roller
Collar
4040IXC208DA
A
Collar
4040IXC209DA
12. Remove the mylar sheets that were attached in
step 10. (Two places)
Note:
Discard the removed mylar sheets.
13. Reinstall the toner supply port.
Note:
Make sure of the correct mounting position and
direction.
14. Reinstall the developing unit cover, ensuring that
its tabs are fitted properly into the slits.
(Three screws)
Tighten this screw first
15. Align the shaft of the developing unit with the
inner guide of the drum unit.
16. Slide the drum unit along the guide to check that
the positioning pin is properly aligned with the
mating hole.
E-7
4040IXC077DA
4030U015AC