Fault Displays - Bosch Vision 800 Series Operating, Care And Installation Instructions Manual

Fault
The laundry was not spun.
(Laundry is still wet).
Unsatisfactory washing
.
result
Detergent residue on the
laundry.
Gray residue on the
laundry.
System shakes or shudders
when passing from lower to
higher speed spinning.

Fault displays

Text in display Possible cause
field
"Check water tap!" "Check water tap!" Water faucets not turned on.
Supply hose kinked or trapped.
Strainer in supply hose clogged.
Water pressure too low.
Aquastop
"Suds or blocked Too much detergent used or pump is blocked.
pump?"
"Check Door!" Door not closed properly.
AquaStop AquaStop
t
Activated"
If the fault cannot be eliminated with the aid of the above table, switch the appliance off, wait 5 seconds, switch the appliance on
again, select and start the cycle.
If the fault continues, call customer service; see Page 32.
Possible cause
Large items of clothing have become entangled and could
not be distributed evenly in the drum. For reasons of
safety the high speed spin cycle was automatically
prevented.
Excessive suds due to too much detergent, non-HE
detergent used
The degree of soiling was higher than estimated.
Not enough detergent.
Some phosphate free detergents contain water insoluble
residues that may appear as light spots on the laundry.
Dirt accumulation from ointments, fats or oils.
Drum system suspension can shift during speed up, this
is not a failure.

Hose safety feature activated.
is triggered
t
Action
Always load the drum with several large and small items
together.
Mix 1 tablespoon of fabric softener with 1 pint (1/2 liter) of
water and pour into the main detergent dispenser
chamber; reduce the amount of detergent used; use HE
detergent. (look for the HE" symbol).
Select suitable cycle
or
Stain removal as an additional option.
Add detergent according to the manufacturer's
specifications.
Brush off spots when laundry is dry.
Add the maximum amount of detergent and select the
highest permissible temperature.
Mix small and large laundry pieces in load to minimize
this effect. Make sure the unit is level, see page 15.
Action
Turn on water faucet. cycle continues.
Eliminate the cause.
Clean the water inlet strainers (see Page 27).
Eliminate the cause.
Check for safety indicator (see page 13). If red, replace
hose.
Use less detergent for future wash loads. Detergents
specifically designed for your High Efficientcy washer
produce fewer suds and will include the letters HE" on the
packaging.
Clean the water drainage pipe and/or drain hose.
Check whether laundry is trapped in door.
Close the door.
Close water faucet and investigate the leak.
Locate and resolve the leak. Check all connections.
Contact Customer Service to reset AquaStop
(refer to Page 32).
t
31