Advertisement
3. Hardware Installation
Before you start using the portable router,
please follow the procedures below to
install and charge the battery.
Note
Step 1:
Remove the battery cover, and insert the
attached battery into the slot. Then replace
the cover back.
Step 2:
Charge the battery by the attached power
adapter and USB cable.
Step 3:
The red
battery is fully charged, the LED will be off.
If you will use the WNRT-300G powered by
AC power supply for a long time, please
remove the battery from the slot and keep
Note
it of full power in a cool and dry place.
Please follow the instructions below to activate the
WNRT-300G
Step 1:
Make sure the operation mode by hardware
switch is Router Mode (default setting).
LED will be lit up. When the
RT/Client/AP
WPS
ON/OFF
5
Advertisement
