Seat Assembly - Toro GreensPro 1200 Service Manual

Seat Assembly

Removal
(Figures 79 through 82.)
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from spark plug.
1
Figure 79
2. Remove lock nut (2), two flat washers (3), and cap
screw (4), and tilt seat pan (1) forward.
5
1
3. Disconnect hour meter wire harness (9) from seat
pan (1).
4. Remove four nuts (6), lock washers (7), and flat
washers (8). Remove seat (5) from seat pan (1).
Chassis
4
2 3
6 7 8
9
Figure 80
10
5
11
10
NOTE: For assembly purposes, note the orientation of
the two seat rails (11) prior to removal.
5. Remove four cap screws (10), and remove seat rails
(11) from seat (5).
1
12 13 14
NOTE: For assembly purposes, note the position of the
flat washers (13) prior to seat pan (1) removal.
6. Remove two lock nuts (12), six flat washers (13),
and two cap screws (14) securing seat pan (1) to
machine.
7. Replace or repair parts as necessary.
Page 5 - 42
10
Figure 81
12 13 14
Figure 82
GreensPro 1200
11
10