Air Conditioning Compressor - Toro Groundsmaster 4000-D Service Manual

Air Conditioning Compressor

7
8
5
6
4
2
3
10
3
11
RIGHT
FRONT
1. Cap screw (2 used)
2. Flat washer (4 used)
3. Lock washer (6 used)
4. Hex nut (2 used)
5. Conduit
6. O- -ring (2 used)
o
7. 90 fitting
Removal (Fig. 1)
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake and remove
key from the ignition switch.
2. Raise hood to allow access to engine.
3. Remove exhaust pipe (item 15).
Operator Cab
21
1
2
14
9
12
8. O- -ring
9. A/C compressor
10. Cap screw (4 used)
11. Cap screw (2 used)
12. A/C compressor mount
13. Flange head screw (2 used)
14. Exhaust bracket
15
13
16
18
17
Figure 1
4. Loosen flange nut that secures idler pulley. Move
pulley to loosen A/C compressor drive belt. Remove
drive belt from A/C compressor pulley.
5. Inspect compressor drive belt for glazing or damage.
Replace belt if necessary.
6. Disconnect compressor electrical connector from
machine wire harness.
Page 9 - - 4
20
15. Exhaust pipe
16. Flange nut
17. Carriage screw
18. Idler pulley
19. Compressor drive belt
20. Engine (model 30603 shown)
21. Clamp assembly
Groundsmaster 4010--D
19