Advertisement
Specific Safety Rules
1. Hold tool by insulated gripping surfaces when performing an operation where
the cutting tool may contact hidden wiring. Contact with
a
''live" wire
will
also make exposed metal parts
of the tool "live" and shock the operator.
2. Be aware that this tool is always in an operating condition, because
it
does
not have to be plugged into an electrical outlet.
3. Always be sure you have a firm footing.
Be sure n o one is below when using the tool in high locations.
4. Hold the tool firmly.
5. Keep hands away from rotating parts.
6.
Do not leave the tool running. Operate the tool only when hand-held.
7. Do not touch the drill bit or the workpiece immediately after operation; they
may be extremely hot and could burn your skin.
SYMBOLS
The followings show the symbols used for tool.
.................................
volts
.................................
amperes
.................................
herts
.................................
kilograms
.................................
hours
.................................
alternating current
.................................
direct current
.................
no load speed
..........................
alternating or direct current
Class
II
Construction
.................................
splash-proof construction
....................
.watertight construction
revolutions or reciprocation per minute
6
.................................
number of blow
4
Advertisement
