Makita 6203D Manual
Hide thumbs
Also See for 6203D:
- Instruction manual (72 pages) ,
- Instruction manual (10 pages) ,
- Instruction manual (49 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Makita 6203D
Summary of Contents for Makita 6203D
- Page 1 Cordless Driver Drill 6203D 6213D/6313D 6233D/6333D...
-
Page 2: Specifications
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Note: Specifications may differ from country to country. For European countries only Noise and Vibration of Model 6203D EC-DECLARATION OF CONFORMITY The typical A-weighted sound pressure level is 67 dB (A). ENH005-1 The noise level under working may exceed 85 dB (A). -
Page 4: Double Insulation
Do not discard batteries into garbage Charging ❏ ❏ can or the like. Charging complete ❏ Note: The recycling method may differ from country to country, or state (province) to state (province). Consult with your near- est Makita Authorized Service Center or Distributor. -
Page 5: Safety Instructions
ENGLISH Explanation of general view Button 10 Switch trigger 19 Adjusting ring Battery cartridge 11 Reversing switch lever 20 Graduations Charging light 12 A side 21 Drill marking Battery charger 13 B side 22 Pointer Tighten 14 Clockwise 23 Limit mark Sleeve 15 Counterclockwise 24 Screwdriver... - Page 6 Do not incinerate the battery cartridge even if it CAUTION — To reduce risk of injury, charge only is severely damaged or is completely worn out. MAKITA type rechargeable batteries. Other types The battery cartridge can explode in a fire. of batteries may burst causing personal injury Be careful not to drop, shake or strike battery.
- Page 7 Approx. 70 min. CAUTION: • The battery charger is for charging Makita battery cartridge. Never use it for other purposes or for other manufac- turer’s batteries. • When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it may not accept a full charge.
- Page 8 Switch action (Fig. 5) Screwdriving operation (Fig. 9) Place the point of the driver bit in the screw head and CAUTION: apply pressure to the tool. Start the tool slowly and then Before inserting the battery cartridge into the tool, always increase the speed gradually.
-
Page 9: Maintenance
Replace carbon brushes when they are worn down to the limit mark. Both identical carbon brushes should be replaced at the same time. To maintain product safety and reliability, repairs, mainte- nance or adjustment should be carried out by a Makita Authorized Service Center. ACCESSORIES CAUTION: •... - Page 12 Makita Corporation 884057A223...