Brake Fluid - Skoda 2014 Rapid Owner's Manual

Hide thumbs Also See for 2014 Rapid:
Table of Contents

Advertisement

Any faults resulting from corrosion may cause a loss of coolant and can con-
sequently result in major engine damage!
Do not fill the coolant above the mark
If an error occurs, leading to the engine overheating, the help of a professio-
nal garage is to be sought - there is a risk of serious engine damage occurring.
Additional headlights and other attached components in front of the air inlet
impair the cooling efficiency of the coolant.
Never cover the radiator - there is a risk of the engine overheating.
Checking the coolant level
Read and observe
and
The coolant expansion bottle is located in the engine compartment.
Coolant expansion reservoir
» Fig. 116
Mark for the maximum permissible coolant level
A
Mark for the lowest permissible coolant level
B
The coolant level should be kept between the marks
The coolant can be checked and topped up, if the following conditions are sat-
isfied.
The vehicle is standing on a horizontal surface.
The engine is turned off.
The engine is not heated.
The bonnet is open.
Checking the level
Check the coolant level in the coolant expansion tank
If the engine is warm, the test result may be inaccurate. The level can also be
above the mark
» Fig.
116.
A
» Fig. 116
on page 133.
A
Fig. 116
Engine compartment: Coolant
expansion reservoir
on page 132 first.
and
.
A
B
» Fig.
116.
In case of low coolant level, in the instrument cluster a check mark
and the corresponding message
coolant level directly at the reservoir from time to time.
Loss of coolant
A loss of coolant is first and foremost an indication of a leak in the cooling sys-
tem. Do not merely top up the coolant. Have the cooling system checked by a
specialist garage.
Replenishing
Read and observe
and
Place a cloth over the cap of the coolant expansion tank and unscrew the
cap carefully.
Replenish the coolant.
Turn the cap until it clicks into place.
CAUTION
Only top up with new coolant.
Do not use an alternative additive if the specified coolant is not available. In
this case, use just water and have the correct mixing ratio of water and cool-
ant additive restored by a specialist garage as soon as possible.

Brake fluid

Introduction
This chapter contains information on the following subjects:
Checking the brake fluid level
Specification
The brake fluid reservoir is located in the engine compartment
page 134.
WARNING
The engine compartment of your car is a hazardous area. The following
warning instructions must be followed at all times when working in the en-
gine compartment
» page
127.
Do not use used brake fluid - the function of the brake system may be im-
paired – risk of accident!
» page
32. We still recommend inspecting the
on page 132 first.
» Fig. 117
Inspecting and replenishing
is shown
134
134
on
133

Advertisement

Table of Contents
loading

Table of Contents