Denon DVD-1710 Service Manual page 8

QQ
3 7 63 1515 0
3. The flat pack-IC on the CBA is affixed with glue, so
be careful not to break or damage the foil of each
pin or the solder lands under the IC when removing
it.
CBA
Masking
Tape
Tweezers
TE
L 13942296513
www
.
http://www.xiaoyu163.com
Hot-air
Flat Pack-IC
Desoldering
Machine
Flat Pack-IC
Fig. S-1-2
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
With Soldering Iron:
(1) Using desoldering braid, remove the solder from all
pins of the flat pack-IC. When you use solder flux
which is applied to all pins of the flat pack-IC, you
can remove it easily. (Fig. S-1-3)
Flat Pack-IC
(2) Lift each lead of the flat pack-IC upward one by
one, using a sharp pin or wire to which solder will
not adhere (iron wire). When heating the pins, use
a fine tip soldering iron or a hot air desoldering
machine. (Fig. S-1-4)
Q Q
3 6 7 1 3 1 5
Fine Tip
Soldering Iron
(3) Bottom of the flat pack-IC is fixed with glue to the
CBA; when removing entire flat pack-IC, first apply
soldering iron to center of the flat pack-IC and heat
up. Then remove (glue will be melted). (Fig. S-1-6)
(4) Release the flat pack-IC from the CBA using twee-
zers. (Fig. S-1-6)
co
.
8
DVD-1710/555
9 4 2 8
Desoldering Braid
Soldering Iron
Fig. S-1-3
Sharp
0 5 8 2 9 9 4 2 8
Pin
Fig. S-1-4
m
9 9
9 9