Enjoying Multiplex Broadcast Sound (Dual Mono); Deactivating The Buttons On The Bar Speaker (Child Lock); Changing The Brightness - Sony HT-NT3 Operating Instructions Manual


To enjoy 3D content, connect a
3D-compatible TV and video device
(Blu-ray Disc™ player, "PlayStation®4",
etc.) to the system using High Speed
HDMI cables, put on 3D glasses, and
then play back a 3D-compatible
Blu-ray Disc™, etc.
 To enjoy 4K content, the TV and
players that are connected to the
system must be compatible with 4K
content.
Enjoying multiplex
broadcast sound (Dual
Mono)
You can enjoy multiplex broadcast
sound when the system receives a
Dolby Digital multiplex broadcast signal.
Note
To receive a Dolby Digital signal, you need
to connect a TV or other devices to the TV
(DIGITAL IN) jack with a optical digital
cable.
If your TV's HDMI IN jack is compatible with
the Audio Return Channel function
(page 26), you can receive a Dolby Digital
signal via an HDMI cable.
Press AUDIO repeatedly until the
signal you want appears in the front
panel display.

"MAIN": Sound of the main language
will be output.

"SUB": Sound of the sub language will
be output.

"MN/SB": Mixed sound of both the
main and sub languages will be
output.
32
GB
Deactivating the buttons
on the Bar Speaker (Child
Lock)
You can deactivate the buttons on the
Bar Speaker (except for ) for
preventing misoperation, such as child
mischief.
Be sure to use the buttons on the Bar
Speaker to perform this operation.
While holding INPUT, press VOL –,
VOL + and VOL – in sequence.
"LOCK" appears in the front panel
display.
You can only operate the system by
using the remote control.
To cancel, while holding INPUT, press
VOL –, VOL + and VOL – in sequence
until "UNLCK" appears in the front panel
display.

Changing the brightness

You can change the brightness of the
front panel display and blue LED
indicator.
Press DIMMER repeatedly.
You can adjust the brightness in
3 levels.*
* The brightness for "DIM1" and "DIM2"
settings are the same.
Note
The front panel display is turned off when
"DIM2" is selected. It turns on
automatically when you press any buttons,
then turns off again if you do not operate
the system for about 10 seconds. However,
in some cases, the front panel display may
not turn off.