Install Alternator Drive Belt And Fan; Install Water Outlet; Adjust Drive Belts - Toyota 7M-GE Repair Manual

EM-36
ENGINE MECHANICAL - Timinn Belt
EM302
EM301
,
A
Alternator
1
EM3000
CORRECT WRONG
WRONG
14. INSTALL ALTERNATOR DRIVE BELT AND FAN
Torque: Fan 55 kg-cm (48 in.-lb, 6.4 N-m)
Adjusting bolt 130 kg-cm (9 ft-lb, 13 N*m)
15. (with A/C)
INSTALL A/C BELT
16. INSTALL WATER OUTLET
install the thermostat with a new gasket and water outlet
with the two bolts.
17. INSTALL SPARK PLUGS
(See page 10-7)
16. ADJUST DRIVE BELTS
Install and adjust the drive belts.
Drive belt deflection with 10 kg or 22 lb:
New belt
A 10 - 12 mm IO.39 - 0.47 in.)
B 7 - 8 mm (0.28 7 0.31 in.)
C MA 7 - 9.5 mm (0.28 - 0.374 in.)
MS 7.5 - 9.5 mm (0.296 - 0.374 in.1
Used belt
A 15 - 17 mm (0.59 - 0.67 in.1 ,
B 9 - 11 mm (0.35 - 0.43 in.)
C MA 10.5 - 12 mm (0.413 - 0.47 in.)
MS 10 - 13 mm (0.39 - 0.51 in.)
(Reference)
Using SST, check the drive belt tension.
SST A 09216-00020
SST B 09216-00030
Drive belt tension:
New belt A 70 - 80 kg
B 65 - 65 kg
C 53 - 77 kg
Used belt A 30 - 45 kg
B 25 - 40 kg
C 30 - 40 kg
NOTE:
0 "New belt" refers to a belt which has been used less
than 5 minutes on a running engine.
0 "Used belt" refers to a belt which has been used on a
running engine for 5 minutes or more.
0 After installing the drive belt, check that it fits properly
in the ribbed grooves.
l
Check by hand to confirm that the belt has not slipped
out of the groove on the bottom of the crank pulley.
l
After installing the belt, run the engine for approx. 5
minutes and then recheck the deflection.