Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
shared—Specifies that the port link type is shared.
•
Default Configuration
The device derives the port link type from the duplex mode. A full-duplex
port is considered a point-to-point link and a half-duplex port is considered a
shared link.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Example
The following example enables shared spanning-tree on gigabitethernet port
1/0/15.
Console(config)#
Console(config-if)# spanning-tree link-type shared
spanning-tree pathcost method
Use the spanning-tree pathcost method Global Configuration mode
command to set the default path cost method. Use the no form of this
command to return to the default configuration.
Syntax
spanning-tree pathcost method
no spanning-tree pathcost method
Parameters
•
long—Specifies that the default port path costs are within the range:
1–200,000,000.
•
short—Specifies that the default port path costs are within the range:
1–65,535.
Default Configuration
Short path cost method.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
462
Spanning-Tree Commands
CLI\files\Spanning-Tree.fm
gigabitethernet
interface
{long | short}
1/0/15
Advertisement
Table of Contents
