Configuration Guide, Worksheet 4 - Toshiba Strata DK24 Installation And Maintenance Manual

F. System and Slot Check
1. Add total PCB/slot requirements (from Worksheets 2 ~ 4): AT + BT + CT1 + CT2 + DT + ET +
FT = PCB/slot total.
One or two additional slots should always be considered for future growth.
2. If total is six or less, use DK24 and PCTUS1 with the following considerations:
a. Total PEKU/PSTU/PESU PCBs combined: three or less (no PEMU equipped).
b. Total PEKU/PSTU/PESU PCBs combined: two or less (PEMU equipped).
c. Total PCOU PCBs: four or less.
d. Total PEMU PCBs: one or less.
e. HDSS consoles: three or less.
f. HDCB controllers: three or less.
g. If using 2000-/3000-/6000-/6005-series electronic telephones and/or a PEMU, use Power
Check, Worksheet 7.
3. If total is six or less, use DK24 and PCTU (1, 2, 3, or 4) with the following considerations:
a. Total PDKU/PEKU/PSTU/PESU PCBs combined: four or less (no PEMU equipped).
b. Total PDKU/PEKU/PSTU/PESU PCBs combined: three or less (PEMU equipped).
c. Total PCOU PCBs: six or less.
d. Total PEMU PCBs: one or less.
e. Combined DDSS and HDSS consoles: four or less.
f. DDCB/HDCB controllers: four or less.
g. If using 2000-/3000-/6000-/6005-series electronic telephones, PDIU-DIs, and/or a
PEMU, use Power Check, Worksheet 7.
4. If total is eight or less, use DK56 and PCTU (1, 2, 3, or 4) with the following considerations:
a. PDKU/PEKU/PSTU/PESU PCBs combined: eight or less.
b. PCOU PCBs: eight or less.
c. PEMU PCBs: two or less.
d. PEMU and PCOU: eight or less.
e. Combined DDSS and HDSS consoles: four or less.
f. DDCB/HDCB controllers: four or less.
g. If using 2000-/3000-/6000-/6005-series electronic telephones, PDIU-DIs, and/or a
PEMU, use Power Check, Worksheet 7.
5. If this total is above eight, use DK96 and PCTU (1, 2, 3, or 4) with the following considerations:
a. PDKU/PEKU/PSTU/PESU PCBs combined: 12 or less.
b. PCOU PCBs: nine or less.
c. PEMU PCBs: three or less.
d. PEMU and PCOU: nine or less.
e. Combined DDSS and HDSS consoles: four or less.
f. DDCB/HDCB controllers: four or less.
g. If using 2000-/3000-/6000-/6005-series electronic telephones, PDIU-DIs, and/or a
PEMU, use Power Check, Worksheet 7.
NOTE:
PDKUs and DDSS s require PCTU3 or PCTU4. DDCBs require PCTU4.
CONFIGURATION GUIDE, WORKSHEET 5
IMPORTANT NOTE!
4-19
INSTALLATION-CONFIGURATION
DK24 with PCTUS1
DK24 with PCTU1, 2, 3, or 4
DK56 with PCTU1, 2, 3, or 4
DK96 with PCTU1, 2, 3, or 4
SECTION 400-096-204
SEPTEMBER 1992