Inspection Of The Voltage Of Peak From The Pulse Generator Power - Honda 2010 CBX 250 Workshop Manual

IGNITION SYSTEM
INSPECTION OF THE VOLTAGE OF PEAK
FROM THE pulse generator power
NOTE
Check the compression in the cylinder and make sure
that the spark plug is properly installed.
Release the connector 8P of Control Module Ignition
(ICM). Connect the adapter from the voltage of peak or the
tips of evidence that the tester Imrie in terminals.
Tools:
Tester Imrie (model 625) and high voltage adapter
07HGJ-0020100 for use with commercially available
multitester (impedance minimal de 10 MΩ/Vcc)
Connection:
Terminal Blue/Yellow (+) Earth chassis ( )
Down the side bracket.
Tap the power switch and place the switch of emergency in
the position RUN. Place the transmission in neutral. Activates
the engine through the mechanism of start and measure the
voltage of peak.
Peak voltage: 0,7 V minimum
In the event that the voltage of pico measure in the connectors
of the ICM is abnormal, measure the voltage
of peak in the connector 3P from the pulse generator
power. Release the connector 3P from the pulse
generator power. Connect the adapter from the voltage
of peak or the tips of evidence that the tester Imrie to the
terminals of connector, on the side of pulse generator of ig-
nition. Measure the voltage of peak with the same procedure
used to measure the voltage in the connector 8P ICM.
Compare the reading with the obtained in the connector
8P ICM. •In case of the voltage of pico measure in the
connector of the ICM is out of the specifications and ten
sion of peak measured in the pulse generator power is
normal, this indicates that there is a circuit interrupted, or
wiring is not in the electrical wiring. •In case of both
measurements are below the value specified, inspect each
item in accordance with the procedures described in the
table of Investigation of Breakdowns (page 17-3).
17-6
CONNECTOR 3P
CBX250
CONNECTOR 8P