Table of Contents
Advertisement
Removing the inner door glass for cleaning
o Do not use any abrasive cleaner that could cause damage.
o Remember that if the surface of the glass panel becomes
o To facilitate cleaning, the door glass can be lifted out after
o When refitting, make sure that the glass is correctly seated in
Installation
o UK Regulations and Safety Standards or their European
o Building Regulations (issued by the Department of the
o Building Standards (issued by the Scottish Development
o IEE Wiring Regulations.
o Electricity At Work Regulations.
o Gas Safety (Installation and Use) (Amendment)
WARNING: THIS APPLIANCE MUST BE EARTHED.
o This appliance should be wired into a 13 A double pole switched
Downloaded from
www.Manualslib.com
scratched, this could lead to a dangerous failure.
removing the fixing screws and turning the metal stoppers that
hold the glass in position.
the door recess and the correct way round, before turning the
metal stoppers back to their original position and fully tightening
the fixing screws.
The installation must be carried out by a suitably
qualified person, in accordance with the current
version of the following.
Norm Replacements.
Environment).
Department).
Regulations.
fused spur outlet, having 3 mm contact separation and the fuse
rating reduced to 3 amps. This should be placed in an easily
accessible position adjacent to the appliance, preferably above
worktop level. An outlet can then be located at the rear of the
appliance for connection.
manuals search engine
22
Advertisement
Table of Contents
