Installing Memory Modules - IBM Netfinity 4500R Installation Manual

Installing memory-module kits

Installing memory modules

m o d u l e k i t s I n s t a l l i n g m e m o r y -
DIMM 1
14
IBM® Netfinity® 4500R Installation Guide
Before you install memory, review the following:
• Your server comes with a dual inline memory module (DIMM) installed in
DIMM connector 1 (J23). Install additional DIMMs as instructed in the
documentation that comes with your option.
• Your server supports 128MB, 256MB, 512MB, and 1GB DIMMs. Your server
supports a minimum of 128 MB and a maximum of 4 GB of system memory. See
the ServerProven™ list on the World Wide Web at
http://www.ibm.com/pc/compat for a list of memory modules for use with
your server.
• Installing or removing DIMMs changes the configuration information in the
server. Therefore, after installing or removing a DIMM, you must save the new
configuration information using the Configuration/Setup Utility program. Refer
to the User's Reference on the IBM Netfinity Documentation CD for more
information.
See the following illustration to install additional memory.
Note: The illustrations in this document might differ slightly from your hardware.
DIMM 2
To install a memory module (DIMM):
Attention: When you handle Electrostatic Discharge-Sensitive devices (ESD), take
precautions to avoid damage from static electricity. For details on handling these
devices, refer to the following Web site and use a search term of ESD:
http://www.ibm.com/
1. Review the safety precautions listed in "Safety" on page v.
2. Turn off the server. Disconnect the signal cables; then disconnect the power cords.
3. Remove the cover.
4. Select the connector in which to install the DIMM.
5. Install the DIMM in the connector.
6. Install the cover.
7. Reconnect the cables and power cords; then, turn on the server.
DIMM connector 4 (J18)
DIMM connector 3 (J19)
DIMM connector 2 (J21)
DIMM connector 1 (J23)