Yamaha YFM90RA Owner's Manual page 98

3
1. Adjusting bolt
2. Cable length "A"
3. Locknut
1. Release the parking brake by moving the
8
parking brake lever to the left.
2. Fully loosen the locknut and the adjusting bolt
at the rear brake caliper.
3. Loosen the locknut on the brake cable.
4. Turn the adjusting nut on the brake cable in di-
rection (a) to increase the cable length, and in
direction (b) to decrease it.
2
1
1. Locknut
2. Adjusting nut
TIP
If the cable length cannot be adjusted to specifica-
tion, consult a Yamaha dealer.
5. Tighten the locknut on the brake cable.
6. Turn in the adjusting bolt at the rear brake cal-
iper until it feels tight, then turn it out 1/8 turn
and tighten its locknut to the specified torque.
NOTICE
When tightening the locknut, hold the adjust-
ing bolt with a wrench so that it does not turn
together with the locknut.
8-25
(b)
(a)
2
1