Belt And Brushroll - Hoover UH20020W Owner's Manual

BELT AND BRUSHROLL

How to Replace
CAUTION
!
To reduce the risk of injury from moving parts
- Unplug vacuum before servicing.
3.13 Lay the cleaner flat and flip it to expose the
nozzle base. The base should lay flat and face up.
Remove the five (5) screws.
3.14 Pull and lift the nozzle guard off.
3.15 Lift and remove the brushroll. Dispose of the
old belt.
3.16 Slide belt onto motorshaft.
3.17 Place new belt in area of brushroll without
bristles.
3.18 With new belt in place, pull and slide brushroll
into nozzle making sure that the brushroll end caps
are in the correct orientation. Rotate brushroll
manually to make sure belt is properly aligned.
3.19 Reattach nozzle guard.
3.20 Secure by aligning the three tabs in the
base slots.
3.21 Replace all five screws to secure nozzle guard.
LUBRICATION
The motor and brushroll are equipped with bearings that contain sufficient lubrication for their lifetime.
The addition of lubricant could cause damage. Therefore, do not add lubricant to motor bearings
and brushroll.
!
3.19
3.13
3.15
3.17
3.20
SLOTS
TABS
11
3.14
3.16
3.18
3.21