Toshiba E-studio 200L User Manual page 19

Job Build (Cont'd.)
7. After scanning is completed, the JOB FINISH button
is displayed on the screen. Each button has the following
functions.
JOB FINISH button: All of the scanned originals are
outputted as the settings, they are stored if this was set,
and then the settings of JOB BUILD are released.
8. Place the originals of the 2nd job.
9. On the Basic screen, set the settings for the 2nd job.
The settings for the 2nd job or later can be changed with
regard to the following functions:
- Reproduction ratio, automatic magnification selection,
original size, other size
- Scanning mode
- Image adjustment mode
- Edge erase, dual-page
When the 1st job is set and 2-sided copying (or 1-sided
copying) is selected, the setting cannot be changed to
1-sided copying (or 2-sided copying) from the 2nd job.
TIPS:
Press the SETTING button to confirm the settings.
To change the settings, press the FC button, and then start the procedure again from step
1.
Be aware that copying will be performed in the same modes as those of the 1st job if the
copy modes are not changed.
10. After completing the settings, press the START button. Scanning the originals starts.
TIPS:
For the 3rd job or later, repeat from step 7 to 10.
Any number of jobs can be set until the total number of
scanned original pages reaches 1000.
11. After having completed all the settings and scanning of the
originals, press the JOB FINISH button on the Basic screen.
When copy and e-file/file functions are set, storing starts.
Page 17