Motorola CPEI 890 Series User Manual page 29

3
Figure 3-5: Wi-Fi Security
Wi-Fi Protected Setup (WPS)
Your CPEi 890 supports Wi-Fi Protected Setup (WPS) to simplify the setup of your
wireless security. WPS can be used to configure client devices such as wireless
adapters in laptop computers that support WPS. If your client devices do not support
WPS, you will have to manually configure those devices. In order to use WPS to set
up your client devices, access the security section of the Wi-Fi configuration by
clicking on the Wi-Fi icon, then clicking on Security. Before you begin, you should
configure the security settings in the CPEi 890 as described in the section above
before continuing.
If you have client devices that do not support Wi-Fi Protected Setup, note the wireless
NOTE
settings, and then manually configure those client devices.
There are two primary options available when utilizing WPS. Use the option below that
applies to the client device you are configuring. NOTE: WPS configures one client
device at a time. Repeat the procedure for each client device that supports WPS.
Option #1, Push Button Control (PBC)
Use this method if your client device has a WPS button. Note that the button may be a
physical button located on the client device or a software button located on the client
device setup screen.
3-16
• There are two options available with the PBC method on the CPEi 890, hard
ware button and software button.
• Hardware button PBC on the CPEi 890
- Locate the WPS button on the back of the CPEi 890 and client device.
Note that the button may be a physical button located on the client
NOTE
device or a software button located on the device setup screen.
Basic Configuration
JAN 2011