Handlebar Block Installation Procedure - Polaris 2005 Sportsman MV7 Service Manual

BODY / STEERING / SUSPENSION

HANDLEBAR BLOCK INSTALLATION PROCEDURE

1. The pin (A) on the bottom side of the top handlebar block faces down and to the front of the ATV.
2. The bottom handle bar block has a side with 3 holes, the side with 3 holes faces up and to the front of the ATV.
3. Align the pin (A) in the top block with the middle hole (B) in the bottom block for proper installation.
The pin (A) and middle hole (B) should face the front of the ATV.
4. Install the pin side bolts first and evenly tighten the bolts down. Evenly torque the 2 front bolts to 11--13
ft.lbs.(15--18 Nm).
5. Install the rear bolts and tighten evenly. Evenly torque the 2 rear bolts to 11--13 ft.lbs. (15--18 Nm).
NOTE: There will be a slight gap on the backside of the blocks after the procedure is performed.
*Install and Torque Front Bolts First
11--13 ft.lbs. (15--18 Nm)
5.14
A
Clean the knurling when
repositioning handlebars.
B