Recoil Housing - Polaris 2005 Sportsman MV7 Service Manual

Breather Filter Orientation -- Arrow To Engine
NOTE: In-line breather filter service life is extended
when the foam air box pre-filter is in place and
maintained properly. Never operate the engine
without the pre-filter.
Breather Hose
Be sure breather line is routed properly and secured
in place. CAUTION: Make sure lines are not kinked
or pinched.

RECOIL HOUSING

B
Recoil
Drain Plug
Recoil Assembly Location
NOTE: For recoil disassembly, refer to Chapter 3.
Drain the housing periodically to remove
G
moisture.
Drain the recoil housing after operating
G
the ATV in very wet conditions.
should also be done before storing the
ATV. The drain screw is located at the
bottom of the recoil housing. Remove the
screw with a 10 mm wrench. Reinstall
screw once housing has been drained.
CAUTION: Make sure the manual start
G
handle (B) is fully seated on the recoil
housing, especially when travelling in wet
areas. If it is not sealed properly, water
may enter the recoil housing and damage
components.
Water will enter the recoil housing if the
G
starter handle (B) is disengaged from the
rope guide when under water.
After travelling in wet areas the recoil
G
housing and starter should always be
drained completely by removing the
recoil.
Do not open the crankcase drain unless
G
the engine has ingested water. Some
MAINTENANCE
This
2.25