Sony MXD-D4 Service Manual page 31

CD SECTION
Set the CD test mode when performing confirmations (refer to page 10).
After completing confirmation, release the CD test mode.
1. COMMAND TRANSFER MENU
Procedure:
(1) Enter the test mode, then rotate
knob.
(2) Select a command with
(3) Select the edit position with
[ AMS ]
L
l (MD) knob for transfer.
(4) To exit from this mode, press the
2. C1, C2 ERROR DISPLAY
Procedure:
(1) Enter the test mode, then rotate
(2) C1 error and C2 error are displayed on the left side and right side with 4-digit codes respectively.
(3) To exit from this mode, press the
3. DISC SPEED SELECTION
Procedure:
(1) Enter the test mode, then rotate
[ AMS
(2) Each time the l
(3) To exit from this mode, press the
4. CHECK 8 DISPLAY
Procedure:
(1) Enter the test mode, then rotate
(2) The time from spindle kick to GFS detect is displayed.
(3) To exit from this mode, press the
5. PORT SELECTION
Procedure:
(1) Enter the test mode, then rotate
[ AMS
(2) Rotate the l
(3) To exit from this mode, press the
6. AMS ON/OFF
Procedure:
(1) Enter the test mode, then rotate
(2) Switch the high speed ON/OFF of the track jamp.
(3) To exit from this mode, press the
7. TRK ON/OFF
Procedure:
(1) Enter the test mode, then rotate
(2) Switch the tracking servo ON/OFF.
(3) To exit from this mode, press the
[ AMS ]
(MD) knob to display "0> COMMAND", and press the
l L
[ AMS ]
l L (MD) knob, and press the
(MD) and (MD) buttons, and rotate
m M
[MENU/NO]
button.
[ AMS ]
l L (MD) knob to display "1> ERROR", and press the
[MENU/NO]
button.
(MD) knob to display "2> SPEED ×1", and press the
[ AMS ]
l L
(MD) knob is pressed, the speed changes over such as ×1 t ×2 t ×4 t ×1.
]
L
[MENU/NO]
button.
[ AMS ]
l L (MD) knob to display "4> CHECK 8", and press the
[MENU/NO]
button.
[ AMS ]
l L (MD) knob to display "7> PORT", and press the
]
L (MD) knob to select GFS, ERROR RATE, RFCK and press the
[MENU/NO]
button.
[ AMS ]
l L (MD) knob to display "8> AMS ON", and press the
[MENU/NO]
button.
[ AMS ]
l L (MD) knob to display "9> TRK ON", and press the
[MENU/NO]
button.
[ AMS ]
l L (MD) knob to set.
[ AMS ]
(MD) knob for editing, then press the
l L
[
l
[ AMS ]
(MD)
l L
[ AMS ]
l L (MD) knob.
[ AMS ]
l L (MD) knob.
[ AMS ]
l L (MD) knob.
[ AMS ]
l L (MD) knob.
AMS ]
L (MD) knob to set.
[ AMS ]
l L (MD) knob.
[ AMS ]
l L (MD) knob.
31