Yamaha FZ1-N 2007 Service Manual page 87

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
FZ1-SA
1. Throttle cables
2. Radiator inlet hose
3. Brake fluid reservoir hose
4. ABS breather hose
5. EXUP cable wire bending attachment
6. EXUP cable
7. Fuel tank breather hose
8. Rear brake light switch lead
9. Rear wheel sensor lead
10.Radiator fan motor lead (right)
11.Coolant reservoir tank hose
12.Right handlebar switch lead
13.Clutch cable
14.Radiator stay
15.Throttle cable (return side)
16.Throttle cable (pull side)
17.Frame
18.Rear brake light switch stay
19.Footrest bracket (right)
20.Rear brake light switch
A. Clamp the front wheel sensor lead
B. To the throttle bodies
C. Clamp the coolant reservoir hose and radi-
ator inlet hose. Point the clamp opening to
the outside of the vehicle and the tip of the
clamp to the front upper side of the vehicle,
and pay attention so that the tip does not
protrude from the radiator cover.
D. Route the fuel tank breather hose and ABS
breather hose by the wire guide. The white
paint position of the hose shall be lower
than the wire guide
E. To the EXUP
F. Pass the fuel tank breather hose, ABS
breather hose and EXUP cable through the
wire guide of the rear brake light switch
stay
G. Clamping position should be placed by the
inner side of the back stay tightening sec-
tion.
H. Tighten the rear brake ground lead
together with the hydraulic unit.
I. Bind the two EXUP cables with the clamp.
For the clamping position, a part of the
clamp should be located within a range of
10 mm (0.39 in) from the end of wire bend-
ing attachment. Any direction of the clamp
opening can be accepted
J. 0–10 mm (0–0.39 in)
K. To the wire harness
L. To the coolant reservoir tank
M. Route the radiator fan motor lead (right) so
that there is no slack as much as possible
in this section
N. Pass the radiator fan motor lead (right)
above the coolant reservoir hose and route
it to the inside of the frame.
email: info@motomatrix.co.uk
O. Pass the coolant reservoir hose to the vehi-
cle inner side of the radiator inlet hose and
route it to the lower outside of the vehicle of
the thermostat assembly.
P. Route in the concavity section of the radia-
tor stay
Q. Route the wire guide of the radiator stay as
shown in the illustration. (Twisting not
allowed)
R. The inside of the vehicle.
S. The front side of the vehicle.
T. Point the clamp head to the outside of the
vehicle and fit it so that the band tip is posi-
tioned at the vehicle front side.
U. The outside of the vehicle.
2-44
CABLE ROUTING