Yaesu FT-2000 Technical Supplement page 23

Adjust T4507, T4509, T4511, T4515, T4517, T4518,
T4519, T4516, T4513 and T4510 on the RX-2 Unit
in succession several times for maximum deflec-
tion on the AF millivoltmeter.
If the Sub S-meter deflects while adjusting, re-
duce the RF Signal Generator output so that the
Sub S-meter does not deflect.
MCF Adjustment
Set the following controls as indicated:
[ANT 1/2] button: ANT 1
[IPO] button: AMP2
[ATT] button: OFF
[AGC] button: AUTO
[RF GAIN] knob: Fully clockwise
[SUB RX] button: ON
Set the Sub Band (VFO-B) frequency to 52.000
MHz in the FM-W mode.
Connect the SINAD mater and 4 Ohm dummy
load to the EXT SP jack.
Connect the RF Signal Generator to the "ANT 1"
jack, then set the output level to 0 dBμ at the
52.000 MHz with ±3.5 kHz deviation FM modu-
lation of a 1 kHz audio signal.
Adjust T4507 and T4509 on the RX-2 Unit in suc-
cession several times for maximum deflection on
the SINAD meter.
If the Sub S-meter deflects while adjusting, re-
duce the RF Signal Generator output so that the
Sub S-meter does not deflect.
T4521
T4501
T4504
T4520 T4507
RX-2 U
IF Trap Adjustment
Set the following controls as indicated:
[ANT 1/2] button: ANT 1
[IPO] button: AMP1
[ATT] button: OFF
[AGC] button: AUTO
[RF GAIN] knob: Fully clockwise
[SUB RX] button: ON
Set the Sub Band (VFO-B) frequency to 50.000
MHz in the CW mode.
Connect the AC millivoltmeter and 4 Ohm
dummy load to the EXT SP jack.
Connect the RF Signal Generator to the "ANT 1"
jack, then set the output level to 60 dBμ at the
40.455 MHz.
Adjust T4520 on the RX-2 Unit for minimum de-
flection on the AC millivoltmeter.
If the Sub S-meter deflects while adjusting, re-
duce the RF Signal Generator output so that the
Sub S-meter does not deflect.
TP4501 T4515
T4509 T4511 T4517
T4510 T4513
A P
NIT LIGNMENT OINTS
Alignment
T4518
T4519
T4516
ALIGNMENT-9
T4508
TP4505
T4512
TP4502