Ember And Lava Rock Placement - Hearth and Home Technologies DV3732 Installation Manual

E. Ember and Lava Rock Placement
Placing the Ember Material
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation. Em-
ber material is shipped with this gas appliance.
To place the ember material:
• Embers CANNOT be placed in pilot bracket area. See
Figure 11.2. Care should be taken not to cover the
lighting trail of ports (from back to front).
• When placing Glowing Embers
should be taken so that the ports are not covered. Place
the dime-size ember pieces near the port holes in the
burner top (see Figure 11.2). Failure to follow this pro-
cedure will likely cause lighting and sooting
• Save the remaining ember materials for use during appli-
ance servicing. The embers provided should be enough
for 3 to 5 applications.
NO EMBERS IN SHADED AREA
Figure 11.2 Placement of Embers
Figure 11.3
Hearth & Home Technologies • DV3732, DV3732L, DV4236 Installation Manual • 2355-980 Rev. H • 3/16
onto the burner care
®
problems..
EMBERS
Placing the Lava Rock
Place lava rock over the remaining burner and base pan
surfaces. (DO NOT COVER THE BURNER PORTS WITH
THE LAVA ROCK) See Figure 11.4.
WARNING
RISK OF EXPLOSION!
• Place lava rock according to instructions.
• Do NOT place lava rock on burner top.
• Use ONLY Hearth & Home Technologies-approved
optional media with this appliance.
• Do NOT use more than 3 pounds of lava rock per
fi replace.
Improperly placed lava rock interferes with proper
burner operation.
Delayed ignition may occur.
Figure 11.4
LAVA ROCK
53