Remote Sensor; Thermo / Hygro Sensor Setup (Rtgr328N) - Oregon Scientific BAR321 User Manual

REMOTE SENSOR

This product is shipped with the RTGR328N Thermo/
Hygro Sensor and an optional UVR138 Ultraviolet Sun
Ray Sensor (BAR323HGN only). The main unit can collect
data from up to 6 sensors (5 Thermo/Hygro Sensors
and 1 UV Sensor). Additional sensors sold separately.
The RTGR328N Sensor collects temperature and
humidity readings, and signals from official time-keeping
organizations for the radio-controlled clock.
For information about the UVR138, refer to the UVR138
User Manual.

THERMO / HYGRO SENSOR SETUP (RTGR328N)

1. Open the battery compartment with a small Phillips
screwdriver.
2. Insert the batteries.
3. Set the channel and radio signal format. The
switches are located in the battery compartment.
SWITCH OPTION
Channel Channel 1 – 5. If you are using
more than one sensor, select a
different channel for each sensor.
Radio Signal EU (DCF) / UK (MSF)
Format
4. Press RESET. Then set the temperature unit.
SWITCH
Temp
5. Close the battery compartment.
6. Secure the sensor with the wall mount or using the
fold-out stand.
FOLD OUT STAND
10
OPTION
°C / °F