Fender CYBER-TWIN Service Manual page 8

NO REVERB
What to check:
- The REVERB control is turned to 1.
- The REVERB INPUT is turned to 1.0.
- FX Kill switch is enabled.
How to solve the problem:
- Turn the REVERB knob on the front panel past 1.
- Press the AMP menu button 6x to get to the REVERB INPUT function, and turn REVERB
INPUT past 1.0.
- Use the FX Kill Footswitch to disable the function.
NO MIDI RECEPTION/ TRANSMISSION
What to check:
- The MIDI connection between the Cybertwin and another MIDI device is incorrect.
- The MIDI RECEIVE CHANNEL on the Cybertwin is set to a different channel than the
transmitting MIDI device.
- The TRANSMIT CHANNEL on the Cybertwin is turned OFF.
How to solve the problem:
- Connect the MIDI cables as follows:
Cybertwin MIDI IN
Cybertwin MIDI OUT
- Press the UTILITY menu button 5x to get to the MIDI RECEIVE CH function and set the
RECEIVE CHANNEL to the same channel as the transmitting device or set the RECEIVE
CHANNEL to OMNI.
- Press the UTILITY menu button 6x and turn the MIDI TRANSMIT CH to the desired channel.
AMP WILL NOT RECEIVE SysEx INFORMATION
What to check:
- The SysEx DEVICE ID is turned to a different value than when the SYSEX data dump was
done.
How to solve the problem:
- Press the UTILITY menu button 7x to go to the SYSEX DEVICE ID function, and set the
DEVICE ID to the same value as when the SYSEX data dump was completed or set the
SYSEX DEVICE ID to OMNI.
CYBER-TWIN Service Manual
!
Device MIDI OUT
!
Device MIDI IN