7. Communicator Touch Panel
7.2
Installation of the touch panel interface
Necessary tools
•
17 mm wrench
•
10 mm wrench
How to install the touch panel interface
1. Assemble the mounting plate and the swivel arm together as illustrated. First place the nut (N) upon the rod of the mounting
plate, then add the lock washer (L), then fasten the mounting plate and the swivel arm together. When the arm is mounted, turn
nut (N) against the arm to secure the position.
Image 7-3
Assemble swivel arm
2. Slide a washer (M) over the base of the swivel arm and Insert the base of the swivel arm into the mounting hole at the top of the
DP2K-23B projector as illustrated.
M
Image 7-4
Mount touch panel
3. Place the touch panel interface on the mounting plate of the swivel arm and fasten the two wing nuts (W) as illustrated.
70
N
L
Image 7-5
Touch panel mounted
R59770495 DP2K-23B 30/04/2010