Remote Control Handling; Operation Failure With The Remote Control; Temporary Run Operation; Replacing The Batteries - Mitsubishi Heavy Industries SRR25ZM-S User Manual

Remote control handling

Replacing the batteries

The following cases show exhausted batteries. Replace old batteries with new ones.
• Receiving beep is not emitted when a signal is transmitted.
• Display fades away.
1
Pull out the cover and take
out old batteries.
2
Insert new batteries.
R03 (AAA, Micro) x2
Pay attention to
the and
marks
3
Close the cover.
4
Press the ACL switch with
the tip of a ballpoint pen.

Warning note for remote control handling

• Do not go near high temperature
places, such as an electric carpet
or a stove.
• Do not put any obstructing
obstacles between the remote
control and the unit display
section.

Operation failure with the remote control

• Are the batteries running down?
"Replacing the batteries" above.
Replace the batteries with new ones and retry the operation.

Temporary run operation

• The unit ON/OFF button on the unit display section operates ON/OFF temporarily when the remote control is not used.
Operation program
• OPERATION MODE :
• FAN SPEED
• Operation starts by pressing the unit ON/OFF button; it stops if you press
the button again.
NOTE
• Do not hold the Unit ON/OFF button down for more than 5 seconds.
(Holding it down longer than 5 seconds sets the automatic cooling used during servicing or when relocating the air-conditioner.)
NOTE
• Do not use old and new batteries together.
• Remove the batteries when the remote control is not used for a long period.
• The recommended effective period of a battery conforming to JIS or IEC
should be 6 to 12 months with normal use. If used longer, or when an
unspecifi ed battery is used, liquid may leak from the battery, causing the
remote control to malfunction.
• The recommendable effective period is printed on the battery. This may be
shorter due to manufacturering time to the unit. However, the battery may
still be in working order after expiry of its nominal life.
■ When the display shows any abnormal condition, Press the ACL switch with the
tip of a ballpoint pen.
Using the remote control holder
The remote control can be attached to a wall or pillar
by using a remote control holder. Before installing the
remote control, check that the air-conditioner receives
the signals properly.
For installing or removing the remote control, move it up
or down in the holder.
Page 11
Strictly prohibited
• Do not leave the remote control
exposed to direct sunlight or other
strong lighting.
• Do not spill any liquid on the
remote control.
AUTO
: AUTO
• Do not drop the remote control.
• Do not place heavy objects on the
• If the operation fails, operate the unit
with temporary operation function.
Contact your dealer to have the remote
control checked.
– 8 –
Handle with care.
remote control, or step on it.
Unit ON/OFF button
Below