Connecting The Ir Blaster; Checking The Ir Blaster; Figure 3-8 Ir Blaster Installed - Motorola DCT3412 Installation Manual

3-16 Installation

Connecting the IR Blaster

To connect the IR Blaster:
1
Fit the transmitter into the mounting bracket (refer to Figure 3-7).
2
Plug the mini-pin connector into the
Figure 3-8
IR Blaster installed
3
Remove the adhesive tape cover from the mounting bracket.
4
Position and press firmly to attach the mounting bracket to the IR receiver on the VCR. Be
careful to route the wire so that it does not prevent loading tapes.

Checking the IR Blaster

The IR Blaster is now located near the receiver and the VCR can be controlled through the
terminal. As a final check, operate the VCR using the remote control from various positions in
the room. If the IR Blaster is obstructing the IR receiver on the VCR, move it slightly.
DCT3412 Installation Manual
jack on the rear panel:
IR