Remote Start Control Module Mounting - Subaru H011SAJ400 Installation Instructions Manual

REMOTE START CONTROL MODULE MOUNTING

7
1. Locate the vehicle's automatic transmission (A / T) module mounted
to the left side of the steering column. (FIGURE V)
2. Route the previously installed windshield mounted antenna harness
and previously installed remote start pre-fit jumper harness towards
the A / T module and plug into the corresponding connectors on the
remote start control module (FIGURE W). Route the remote start
ignition harness towards the A / T module and plug into the
corresponding connector on the remote start control module
(FIGURE W). Double check all connectors to ensure a secure fit.
3. Secure the remote start control module to the left side of the A / T
module using the supplied velcro making sure the remote start ignition
harness connector is facing down (same direction as the A / T module
connector). (FIGURE X)
4. As a secondary mounting provision, secure the remote start control
module to the A / T module using the supplied 21" tie wrap (route the
tie wrap between the 12-pin and 5-pin connectors on the remote start
control module and through the right side of the A / T module bracket).
(FIGURE X)
5. Using the supplied 8" tie wrap, secure excess remote start jumper
harness and antenna harness wiring to the existing vehicle wiring near
the prefit connectors behind the fusebox. (FIGURE Y)
6. Using a supplied 8" tie wrap, secure the mated remote start harness
6-pin male and vehicle's 6-pin female connectors to the factory ignition
harness. (FIGURE Z)
7. Route the remote start ignition harness down the right side of the
steering column following the factory ignition harness and secure to
the factory ignition harness in two (2) places using the supplied 8" tie
wraps (FIGURE Z).
NOTE: After the remote start control module has been mounted
and all wiring secured, operate the tilt / telescopic fully to ensure
that the new components do not interfere with operation of the
tilt / telescopic feature.
PART NUMBER ISSUE
H011SAJ400
DATE
00
21 Apr 2013
A/T Module
Ignition Harness
Connector
A/T Module
Tie Wrap
SUBARU OF AMERICA
Brake Pedal
FIGURE V
Antenna Harness
Jumper Harness
Connector
Connector
FIGURE W
Brake Pedal
FIGURE X
RES Module
FIGURE Y
FIGURE Z
7 OF 11