Refractory Brick Panel Installation Instructions - Lennox SHRL 33 DV INS Installation And Operation Manual

SHORELINE™ REFRACTORY BRICK INSTALLATION INSTRUCTIONS
Tools Needed: No tools are needed
Cat. No. Model
H7987 SHR-BRK-STD
H7988 SHR-BRK-RED
H7989 SHR-BRK-ARCHSTONE
Refractory Brick Panel Kits - Packaging List
Quantity
1 Front Bottom Panel (A)
1 Rear Panel (B)
1 Left Side Panel (C)
1 Right Side Panel (D)
1 Top Panel (E)
Table 7 - (refer to Figure 14)
IMPORTANT NOTE: A refractory brick panel kit is required for proper
operation (sold separately). Never operate this appliance without
all the refractory brick panels properly installed.
Figure 14
Before you install the refractory brick panels and log
set, the insert should be installed in the fireplace, the
venting attached, the gas line connected and tested
for leaks and the initial burner operation checked.
To Install Panels:
1. Start with the front bottom panel A. Set the front bottom panel in
place with detail side facing up as shown. See Figure 15.
Figure 15
14
Description
Brick Panel Set, Tan
Brick Panel Set, Red
Brick Panel Set, Architectural (shown)
Models SHR33 & SHR40
Description
E
C
D
B
A
CAUTION
A
2. Next place the rear panel (B). It will set on the bracket mounted to the
blower mounting plate on the back of the firebox. See Figure 16.
Figure 16
3. Position and slide the side panels against the rear panel. Make sure
panels are behind brackets to hold them in at the top. The side panels
will hold the rear brick panel against the back of the firebox. See Figure
17.
C
Figure 17
4. Slide the top panel in place with the detailed side down. Make sure
panel is positioned all way back and resting on side panels. Top panel
should be flush in front with the side panels. See Figure 18.
Figure 18
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE
B
D
E