D-Sub Pin Description; D-Sub Connector - Philips Magnavox 15MF400T/37 Service Manual

15" LCD-TV Color Monitor
3. D-SUB Pin Descriptions

3.1 D-SUB Connector

This procedure gives you instructions for installing and using the LCD TV display.
1. Position the display on the desired operation and plug the power cord into a convenient AC outlet.
Three-wire power cord must be shielded and is provided as a safety precaution as it connects the chassis
and cabinet to the electrical conduct ground. If the AC outlet in your location does not have provisions for
the grounded type plug, the installer should attach the proper adapter to ensure a safe ground potential.
2. Connect the 15-pin color display shielded signal cable to your signal system device and lock both screws on
the connector to ensure firm grounding. The connector information is as follow:
PIN NO.
1.
2.
3.
4.
5.
6.
7.
8.
3. S-Video ( Y /C ):
TV:
Video:
Audio:
Audio Input for AV,S-Video, RCA female ( Red / White )
Headphone
4. Apply power to the display by turning the power switch to the "ON" position and allow about ten seconds for
Panel warm-up. The Power-On indicator lights "GREEN" when the display is on.
5. With proper signals feed to the display, a pattern or data should appear on the screen, adjust the brightness
and contrast to the most pleasing display, or press auto-adjust to get the best picture-quality.
6. This TV (with PC function) has power saving function following the VESA DPMS. Be sure to connect the
signal cable to the PC.
7. If your TV requires service, it must be returned with the power cord.
6
11
15 - Pin Color Display Signal Cable
DESCRIPTION
Red Video
Green Video
Blue Video
RS-232 TX
GND
Ground-R
Ground-G
Ground-B
TV rear side
TV rear side
TV rear side
TV rear side
3.5mm female
1
5
10
15
PIN NO.
9.
10.
11.
12.
13.
14.
15.
: 4 pin Mini-DIN female
: IEC type female
: RCA female (Yellow )
: RCA female (Red / White )
18
15MF400T/37
DESCRIPTION
VGA_5V
Sync Ground
RS-232 RX
Serial Data for DDC
Horiz. Sync
Vert. Sync
Serial Clock for DDC