Table of Contents
Advertisement
If the stand is provided, please read these instructions thoroughly before attempting this installation.
You must install your TV into the stand in order for it to stand upright on a cabinet or other flat surface. If you intend to mount
your TV on a wall or other vertical surface, you must remove the stand column.
Cautions:
Make sure that you handle your TV very carefully when attempting assembly or removal of the stand. If you are not sure of
your ability to do this, or of your ability to use the tools necessary to complete this job, refer to a professional installer or
service personnel. The manufacturer is not responsible for any damages or injuries that occur due to mishandling or
improper assembly.
The speaker is not intended to support the weight of your TV. Do not move or handle your TV by the speaker. This can
cause damage to your TV that is not covered by the manufacturer's warranty.
Before attempting assembly or removal of the stand, unplug the AC power cord.
Installing the stand
Stand
NOTE:
The appearance of this product in these illustrations may differ from your actual product, and is for comparative
purposes only.
Appendix: Installing the Stand
To install the stand:
1. Remove the stand from the box and place it on a table or
2. Lay your TV flat (screen down) on the edge of a table or
Locators
3. Put the stand close to the TV back, align the stand with the
Secure with
three screws
To remove the stand from the TV, perform these steps in
reverse order.
26
bench.
You must pay attention to the direction of the stand. The
wide portion of the stand should go towards the front of the
TV.
bench. Make sure that you put down a soft cushion or cloth
so that your TV is not scratched.
TV by moving the stand steadily until the Locators align with
the locating grooves on the stand. And align the screw holes
on the TV back with the holes in the stand, then secure the
stand to the TV with provided screws .
Advertisement
Table of Contents
