Service Installation Of Key Operated Switch To Deactivate Front Passenger Side Airbag E224 - Audi A8 2003 Workshop Manual

– Unplug the connector -1-.
– Press on the retaining springs -arrows- with a screwdriver.
– Press out the key operated switch to deactivate front passen‐
ger side airbag -2- to the front.
– Insert the key -3- in the lock -2-.
– Destroy the key switch -1- with the key -3- inserted.
– Break out the lock -2-.
Installing
– Press the lock -2- with the key -3- inserted into the new key
switch -1- until the lock -2- engages.
Perform further installation of the key operated switch to deacti‐
vate front passenger side airbag in the reverse order of removal.
Pay attention to the following:
– Make sure the key switch is properly engaged in the glove
compartment.
– Switch on the ignition after installing the key switch.
WARNING
There must not be anyone in the vehicle when connecting the
battery.
– With the ignition switched on, connect the battery earth wire
⇒ Electrical system; Rep. gr. 27 .
Note
If the airbag warning lamp -K75- indicates a fault following instal‐
lation, the event recorder must be interrogated, erased and inter‐
rogated again ⇒ Vehicle diagnostic tester.
5.3 Service installation of key operated
switch to deactivate front passenger
side airbag -E224-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
For service installation of the key operated switch to deactivate
with respect to the correctness of information in this document. Copyright by AUDI AG.
front passenger side airbag, refer to
General body repairs, interior - Edition 07.2011
5. Servicing front passenger side airbag N131
Audi A8 2003 ➤
133