Table of Contents
Advertisement
Azalea®
7.2 Material
Chassis, backrest tubes
Plastic parts like push handles, brake handles, foot plates and parts
of most accessories
Upholstery (seat and backrest)
Table
Seat plate
Other metal parts
Screws, washers and nuts
7.3 Environmental conditions
Temperature
Relative humidity
Atmospheric pressure
Be aware that when a wheelchair has been stored under low temperatures, it must be adjusted to operating conditions before use.
7.4 Electrical system — Azalea with electric tilt and backrest
Voltage supply
Maximum current input
Intermittent (periodic
motor operation)
Insulation class
Degree of protection
For full details, also read the documentation from the manufacturer. Download manual(s) from www.linak.com or contact your Invacare
dealer.
7.5 Electromagnetic compliance (EMC)
General information
Products with electronic equipment needs to be installed and used according to the EMC information in this user manual.
WARNING!
Portable and mobile communications equipment can affect the operation of this product.
This product must not move unintentionally while being submitted to Electromagnetic interference
– If this should happen; the product must immediately be taken out of use and checked by a trained technician.
This product has been tested and complies with the EMC limits specified by IEC 60601-1-2 for Class B equipment.
This product has a very low emission and should not interfere with other equipment.
However, if other devices nearby should react inexplicably, run and stop this product and observe the devices.
•
If nothing happens with the other devices, then this product is not causing the error.
•
If other devices are behaving in an inexplicable manner, then this product is causing the error. Solve the problem by moving or
increasing the distance between them.
34
Storage and transportation
Uin 220 Voltage, AC, 50 Hz (AC = Alternating current), DC 24 V (DC = Direct current)
Iin max. 2,3 Ampere (battery = max 1,3 Ampere)
10 % 2 min ON / 18 min OFF
CLASS II equipment
Applied Part complying with the specified requirements for protection against electrical shock according to
IEC60601-1.
The control unit, external power supply, motors and hand controls are protected according to IPx6. See
label and label on each electric device for correct IP class. The lowest IP-classification decides the overall
classification of the system.
IPx6- The system is protected against water projected from any direction (not high pressure).
Steel, powder coated
Thermoplastic (e.g. PA, PE, PP, ABS and TPE) according to marking
on the parts
Foam PUR and Polyether, fabric Dartex® and plush
ABS
Coated Birch plywood
Zink alloys, aluminium alloys and steel
Steel, corrosion free
-10º C to +50º C
20% to 75%
800 hPa to 1060 hPa
Operation
-5º C to +40º C
1580313-B
Advertisement
Table of Contents
