Fitting The Receiver - Worcester MT10RF Instruction Manual

4

FITTING THE RECEIVER

B
E
D
C
FITTING & OPERATING INSTRUCTIONS FOR WORCESTER BOSCH
A
1
2
MECHANICAL RF STAT TRANSMITTER & RECEIVER
8-716-106-196 issue a (10/03) UK
FITTING THE RECEIVER
DANGER - 24V &
230V:
DO NOT TOUCH
THE ELECTRICAL
COMPONENTS OR
CIRCUITS.
CAUTION: ISOLATE THE MAINS
ELECTRICITY SUPPLY BEFORE
STARTING ANY WORK AND
OBSERVE ALL RELEVANT
SAFETY PRECAUTIONS.
OBSERVE ELECTRONIC STATIC
DISCHARGE PRECAUTIONS.
DO NOT TO TOUCH THE PCB
CIRCUITS
Remove the programmer blanking
plate or existing programmer from
the boiler control panel - refer to
the relevant boiler Installation and
Servicing instruction manual and
existing programmer instructions for
details
1 Attach receiver connector (A) onto
circuit board (B) at 'ST5' shown
with a clock symbol
2 Locate receiver lower lug (C) into
control panel slot (D) and check for
trapped wires before clipping the
top lug (E) of the receiver into the
control panel
Switch boiler on when completed.