Network Setup - D-Link DCS-5009L User Manual

Section 4 - Configuration
This section allows you to configure your network settings.
DHCP: Select DHCP if you have a DHCP server running on your network
and would like a dynamic IP address to be assigned to your camera
automatically.
Static IP Address: Select this connection type if your Internet Service Provider (ISP)
or network administrator has provided you with a static or fixed IP
address and other network information for your camera.
IP Address: Enter the fixed IP Address for your camera.
Subnet Mask: Enter the Subnet Mask for your network. This value
is used to determine if the destination is in the same subnet as host
devices. The default value is 255.255.255.0.
Default Gateway: Enter the address for the gateway used to forward
data to destinations in a different subnet. Invalid gateway settings
may cause the failure of transmissions.
Primary DNS: Enter the IP address for the primary domain name server
that translates names to IP addresses.
Secondary DNS: Enter the IP address for the secondary domain name
server to backup the Primary DNS.
PPPoE If your camera is directly connected to the Internet through a DSL
modem, you may
and enter the User ID and Password provided to you by your ISP or
network administrator.
Port Settings: You may configure a second HTTP port that will allow you to connect
to the camera using a standard Web browser. The port can be set to a
number other than the default TCP port of 80. A corresponding port
must be opened on the router. For example, if the port is changed
to 1010, users must type http://192.168.0.100:1010 instead of
http://192.168.0.100.
UPnP Settings: Enable this setting to configure your camera as a UPnP (Universal Plug
and Play) device in the network.
UPnP Port If you enable UPnP port forwarding, it will allow the camera to
Forwarding:
communicate with a UPnP compatible network router for simplified
local network access and remote access using the Internet.
D-Link DCS-5009L User Manual

Network Setup

connect to the Internet using PPPoE. Click on PPPoE
30 30